Common Appliance Repair Solutions
|
Main
|
|
 Belt repair on a dryer
This was wonderful. I had never done such a things. Easy as 1,2,3
Thanks for your help!
Mary [2009-09-10] |
|
Maytag Dryer Belt
Maytag dryer belt placement diagram very helpful. The diagram that came with the belt (Not from your company) was incorrect. Thanks for the help.
Jim (08/13/09)
James Asberry [2009-08-13] |
|
Maytag Dryer Belt
I spent the better part of an hour trying to assemble the BELT. Finally, I gave up and searched for this on the Internet. I had the belt on in less than 5 minutes! Thank you!
Jim Martin [2009-06-30] |
|
Anonymous' comment on 11/25/07 really helped. If you've never fixed a dryer before and the belt has snapped, you have no idea where the belt is supposed to go! I thought it went into that groove in the back as well, until I read the comment. Everything is working now. Thanks, mysterious stranger!
[2009-03-02] |
|
maytag belt routing (and positioning)
very helpful - additional information on where the belt rests when installed was also helpful.
I have a worn mark where the belt should go but had thought that it would go in the grove just behind the pullies. Not so.
[2008-08-25] |
|
Belt diagram
Very helpful and about the only place I've found such a diagram. Thanks!
Doug [2008-02-18] |
|
belt position on drum
Thanks for the belt routing info. One thing I discovered that wasn't immediately obvious is that the belt is not supposed to contact the drum in the groove that looks like it might be for that purpose. If it does it there will not be enough tension on the belt, the idler will be at the wrong angle and the metal belt guide will rub on the belt. I did find that putting the belt in that groove while routing it around the idler/drive gave me more slack, then once that was on I moved the belt to it's correct position by moving it out of the groove on one side and rotating the drum until it was completely out of the groove. I hope this helps others who might have been tripped up like I was.
anonymous [2007-11-25] |
|
dryer belt routing
Very helpful. As simple as you would think it should be...it can be most confusing if you haven't done it in awhile. Your website is listed in my favorites now.
Thanks,
Gabe
Gabe [2007-08-31] |
|
Dryer Belt
Yes, the article about how to route the Maytag dryer belt was extremely helpful and a real time saver!!! Thank-you :)
Jim Bogart [2007-07-29] |
|
Routing Dryer Belt
The sketch was great without it I wouldn't of gotten it done. I did use a mirror image working from the front. I also had an easier time using a small block of wood to position the idler and then threaded the belt around the pulley and idler followed by sliding the tumber into position while guiding the belt around the tumber. Then removed the block of wood. It worked and turned out to be easier for me.
Thanks again.
T. Levy [2007-07-17] |
|
dryer belt
Yes, your diagram was very helpful. Thank you
ton nickel [2007-04-03] |
|
dryer belt diagram
than you for your article of the positioning fo the dryer belt this was extremely helpful.
James Laney 02/25/07
James Laney [2007-02-25] |
|
Drum belt diagram
very helpful diagram. how to install a new belt will be even more
helpful. thank you very much.
Juan Castaneda [2007-02-02] |
|
Maytag Dryer repair
Yes, your diagram was very helpful. Thank you
Dan Beamer [2006-12-15] |
|
Maytag Dryer
The article on the Maytag dryer that contained the positioning of the dryer belt was very helpful. Thanks
Joe Minder [2006-11-28] |
|
We would appreciate your comments on this article. Was it helpful to you? How can we improve its content? Did you successfully complete your repair with this information? Your input is what helps us to become better.
|
Notice:
This form should only be used to submit comments regarding the article you were viewing. If you have a diagnostic question, it should be submitted using the Diagnostic Questionnaire
|
|
|
|
|
|
|
|
